After setting up my new Ortur laser master 3 I powered it on, and Lightburn recognized it.
Now I tried to run a small design, and all it would do is run x axis (side to side) in the same spot. I tried to pause and nothing happened, it just kept running. I hit stop and it did stop. I tried to go home and nothing happened. It will not go Y axis back and forth, only side to side. Any help would be greatly appreciated.
Ortur laser master 3
Re: Ortur laser master 3
Mine is doing same thing ( ortur Laser master 3 ) - anybody know whats going on here - I have an e-mail out to Ortur - just started out of the blue.
-
wolfy1beer
- Full Member
- Reactions:
- Posts: 51
- Joined: Fri May 20, 2022 3:50 am
- Location: Peterborough England
- Contact:
Re: Ortur laser master 3
Flip the YRR Switch at the Top Rear Left of the machine.
Hi All. I'm Bob & have been messing around with Lasers for a couple of years now. I have a Genmitsu LC-40 & an Ortur LM3 And now an Enjoywood E20 
Even more to learn 
Even more to learn -
Wyked
- Laserologist
- Reactions:
- Posts: 424
- Joined: Mon Jun 20, 2022 11:00 pm
- Location: Perth Western Australia
Re: Ortur laser master 3
If not that, check it is not turned on for rotary in software somewhere.wolfy1beer wrote: ↑Fri Jul 21, 2023 10:50 pm Flip the YRR Switch at the Top Rear Left of the machine.
Atomstack P7 M40-Dead and Atomstack A5 M50 Pro+ replaced module with M100 (Extension Kit, Air Assist and R3 & Chuck Roller), K40 Co2
Also 3D Printer and CNCs 3018, Foxalien Masuter Pro 4040.
Housed in "The Laser Lair"
Eternal Learner.
Also 3D Printer and CNCs 3018, Foxalien Masuter Pro 4040.
Housed in "The Laser Lair"
Eternal Learner.
