NEJE A40460
-
ecsoftball
- Noob
- Reactions:
- Posts: 5
- Joined: Tue Oct 26, 2021 10:10 am
NEJE A40460
I purchased the NEJE A40460. I have the Ortur master laser2 pro that is 24 volt. So now I'm looking at the NEJE A40460 (no instructions of course) 12 volt with no idea how to hook this up. I have searched high and low on youtube with no luck. Does anyone know how I would make this work, or point me in the right direction?
Re: NEJE A40460
Hi, you just use a separate 12v power supply for the laser,
You do not have the required permissions to view the files attached to this post.
Re: NEJE A40460
My test button won't fire the laser. Does yours?
Randy, Ortur Laser Master 2 20w with Neje 40w upgraded laser module. I've been doing this for about a year.
-
LAHobbyGuy
- Laser Yoda
- Reactions:
- Posts: 2911
- Joined: Mon Jun 28, 2021 10:17 am
- Location: New Orleans, Lousiana
- Your Specific Hobby: Laser Engraver
- Contact:
Re: NEJE A40460
You have to disconnect the red pin coming from the control board of the Ortur by pulling it out of the connector with a plyer and tape it off. Then the power has to come from the power supply that Neje sent with the laser module. That plugs into the adapter board on top. You have to run two power supplies with the 24V Ortur.
Rich
Rich
inspire.. create.. learn.. teach.. help someone today... Subscribe to my YouTube Channel, The Louisiana Hobby Guy!
PLEASE DO NOT PM ME OR EMAIL THE ADMIN! THIS FORUM WAS DESIGNED TO ANSWER YOUR QUESTIONS!
New Here? Main Forums --> Start Here --> Everyone Please Read
PLEASE DO NOT PM ME OR EMAIL THE ADMIN! THIS FORUM WAS DESIGNED TO ANSWER YOUR QUESTIONS!
New Here? Main Forums --> Start Here --> Everyone Please Read
