Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Sparty1965 wrote: ↑Thu Feb 03, 2022 8:41 am
Re: Emojis in LB. When I click on Edit in LB at the bottom of the drop down it clearly says Emoji and Symbols. When I click on it multiple pages of Emojis and symbols open up but I can't figure out how to load them onto the layout screen.
Rich, re: the emojis question. I have tried to send screen shots of the edit menu as you did to me and also of the emojis and symbols that open up when I click on them in the edit memo but cannot seem to get them into your email system. I guess I'm not sure why this is Mac issue when it is an option in the LB Edit menu..
I would appreciate any further ideas you have. I really appreciate your help.
Sparty1965 wrote: ↑Fri Feb 04, 2022 8:58 am
I guess I'm not sure why this is Mac issue when it is an option in the LB Edit menu..
It's not an issue, it's a Mac only feature. I don't own a Mac so I can't help you with it. You can try and ask on the Lightburn support forum for help.
Hi I am new to forums and Laser engravers. I have a Sculpfun s9 which is a recent purchase and I am a complete beginner. I have down loaded and 3d printed a air assist adapter which fits well and seems ok, but the hole in the bottom for the laser beam to emerge seems a bit small. What size should be, is there a spec for this?
Thanks
Archdouglas wrote: ↑Sat Feb 05, 2022 2:49 pm
Hi I am new to forums and Laser engravers. I have a Sculpfun s9 which is a recent purchase and I am a complete beginner. I have down loaded and 3d printed a air assist adapter which fits well and seems ok, but the hole in the bottom for the laser beam to emerge seems a bit small. What size should be, is there a spec for this?
Thanks
Between 2 and 3 mm is good. A fine jet blowing into the cut will clear out most carbon and ash debris. Blows it everywhere though lol! but that's what it's for.
Machines: Sculpfun S9, Neje LM2 20W and 30W modules, Atomstack M50 module. I'm retired with interests in home shop engineering, astrophotography, and a whole lot of other stuff. Avatar is my dog Hazel who's much better looking than me.
I downloaded your burn test and ran it on a Acacia Cutting board there was very little difference the burn of each square, I will attach some pictures.
I have a Ortur LM2 Pro, 20wat,
I am using Lightburn Software, I am new to both.
You do not have the required permissions to view the files attached to this post.
David, I have a LM2Pro, 20w, new to the laser game. I have Mira 7 on order.
I've got a problem with my Sculpfun S9 Laserengraver.
I have the laser for a week now, and i love it!
But, since today, the laser is wiggeling, as it runs.
So i can't get straight lines.
What i already did:
- Tightend the belts.
- Fastend the screws on the laser unit, wich are holding the little wheels.
- cleaned the belts.
New Here? Main Forums --> Start Here --> Everyone Please Read
