I have been waiting on Monport Support all week, but thought I would ask the forum.
I have an 80w Monport C02 Laser, it at first gave me the Water Sensor warning, then went into a system rebooting cycle, then just died. No power on the control, but power is still being routed to my chiller from the aux plug in the back. I figured I had a bad pwr supply, so I ordered and change out the pwr supply box. No Joy, System is still dead, no lights on the pwr supply or any of the boards. What am I missing???
Oh additional info.
Changed both fuses as well. And the air pump for the laser still works.
I'm lost at the moment.
Steve
Monport 80w C02 Laser with no power input
Monport 80w C02 Laser with no power input
Hi my name is Steve, I own a 80w Monport and now running a small engraving and sublimation business
Re: Monport 80w C02 Laser with no power input
Follow up for anyone interested.
After lots of troubleshooting I determined I have a bad 24 volt power supply.
Now try to find on in the US ~ good luck. Especially with a 5 volt lug to power your laser red dot.
Monport finally responded but they do not do well with photos and a complete illustration on my steps.
I had to do videos and this lasted over a week. They finally agreed I have a bad supply, but still did not have a place for me to order one here.
I am now waiting for another 12 days while they ship me one.
After lots of troubleshooting I determined I have a bad 24 volt power supply.
Now try to find on in the US ~ good luck. Especially with a 5 volt lug to power your laser red dot.
Monport finally responded but they do not do well with photos and a complete illustration on my steps.
I had to do videos and this lasted over a week. They finally agreed I have a bad supply, but still did not have a place for me to order one here.
I am now waiting for another 12 days while they ship me one.
Hi my name is Steve, I own a 80w Monport and now running a small engraving and sublimation business
