I have been using my laser for about 10 months no problem. I have not used it in a couple of weeks, when i went to use it today, i get " device atttached to USB port not recognized by windows"
what could be causing this error?
USB error
-
KnightRid
- Global Moderator
- Reactions:
- Posts: 2155
- Joined: Thu Aug 18, 2022 4:19 pm
- Location: Dallastown, PA
Re: USB error
bad cable, bad connector, bad motherboard.
I wold try a different USB port and see what happens. If you still get the error then try a new cable.
I wold try a different USB port and see what happens. If you still get the error then try a new cable.
Hi my name is Mike and I use a Roly Automation LaserMATIC10 and a Creality Falcon 10w diode laser.
Hobby Forums --> Start Here -- Everyone Please Read
Hobby Forums --> Start Here -- Everyone Please Read
-
martinmarty
- Laserologist
- Reactions:
- Posts: 690
- Joined: Wed Dec 14, 2022 4:56 pm
Re: USB error
Your port number could have changed if you have plugged in different USB devices during your period of not using laser. If you go into Windows Device Manager and look at the USB devices you should be able to figure it out. See what appears or disappears when you turn the laser off and on. Make sure your software is configured with the correct device name.
My name is Marty. Started this hobby Dec. 2022. Using Roly LaserMATIC10 with Lightburn on Windows.
Hobby Forums --> Start Here -- Everyone Please Read
Hobby Forums --> Start Here -- Everyone Please Read
Re: USB error
Thx guys. I just kept unplugging and plugging back in and it finally recognized it. I think the cable will have to be replaced.
Thx again for all your replies
Thx again for all your replies
Hey, Bob here. I have a Neje 3 Plus, In this arena for about 2 months.
