In this video, I take you through all the steps to create a 3-D replica of the Eiffel Tower!
Requires:
Diode Laser – 5 Watt Optical Output and above
C02 Laser – 20 Watt and above
Minimum Bed Size: 300×200 mm
Lightburn Software (Click here for a trial version), Version 0.9.24 or newer
You can purchase this Lightburn file in my online graphics store:
https://engraveandcutfiles.com/
Hi Rich… I purchased the Eiffel Tower plans and downloaded them but when I put the test piece in LightBurn and sent it to my laser it skipped some of the lines in the test piece and cut others. I finally got it to cut all the lines and it looked good but I don’t know what I did to fix it. Then I tried to cut another section and the same thing happened. It cuts some of the pieces and skips others. I’m using the Ortur LM2 Pro. I’ve never had this to happen before. Any suggestions would be appreciated. Thanks.
I figured it out. Awesome project. Can’t wait to finish cutting and assembling it.
I am having the same issue with the same machine. What did you figure out that was causing the issue? Any help would be appreciated.
All I know for sure that I did was go into cuts and layers and turn off the constant power mode. I don’t know for sure if that’s what did it but I never had any problem after that.
Thank you. I saw late last night the the constant mode was turned on for 2 of the 3 layers. I turned them off and saved the file but did not get a chance to test it yet.
I laser cut the Eiffel Tower and my grandson and I glued it together this past week. This is a great model and especially fun to do it with your kids or grandkids. Thanks Rich for all the work you did fine tuning the model. You can see a picture of it on my Facebook page. https://www.facebook.com/1314586583/posts/10226859361492796/
Hi Rich,
I downloaded your Eiffel tower, cut great. When I try to place the first floor on top of the base frame, left and right side fit great, but top and bottom taps does not line up. I’m 83 and I have put together all of things. Did do I have download again, the bottom is square is and the first floor is square it just the taps are out of line.
Take care
Have a nice Day!!
They only fit in one direction.